[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Fri, 13 Apr 2018 22:40:39 +0100
The piece I am setting has a flute cadenza which is notated in standard
size notes totalling 14 crotchets (quarter-notes) in length. The whole
cadenza is written between 2 successive barlines.
The prevailing time signature at this point is 6/8, and in the cadenza
all of the other instruments have a tied dotted minim with a fermata.
I have been trying to reproduce this layout in LilyPond, using
v.2.19.81. I tried \cadenzaOn etc., but that did not seem suitable. I
then tried to adapt the snippet found at
http://lsr.di.unimi.it/LSR/Item?id=836 . Using this, the cadenza bar
itself works OK, but in subsequent bars Lilypond seems to think that
the time signature is 4/4.
I conclude that the line '\unset Timing.measureLength' restores
measureLength to its default value, rather than restoring the previous
value. I tried removing that line and adding '\once ' before
'\set Timing.measureLength', but this fails completely.
I have now replaced the line
\set Timing.measureLength = #(ly:make-moment 3/4)
This works fine, but how would I get a more general solution which
could be used in cases which are not in 6/8 or 3/4?
- Cadenza problem,
David Sumbler <=