[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Ltib] anti-freeze imx27 pm patch
From: |
Stuart Hughes |
Subject: |
Re: [Ltib] anti-freeze imx27 pm patch |
Date: |
Fri, 22 Feb 2008 13:50:03 +0000 |
Hi Peter,
Thanks for the follow-ups. It's probably worth contacting Freescale,
the developer for this platform may have some ideas.
Regards, Stuart
On Fri, 2008-02-22 at 12:51 +0000, Peter Wurmsdobler wrote:
> Hello,
>
> > a key on the keypad wakes it up. However, if I press a key on the keypad
> > a short time after the entering the echo command (presumingly while the
> > system is suspending), the board freezes.
> After several trials I have found that the system wakes up only the very
> first time. If I issue an echo > /sys/power/state a second time, it will
> never come back, independently how long I wait to press the key:
>
> mx27# echo mem > /sys/power/state
> Stopping tasks: ===============|
> Suspending console(s)
> mmc_setup - SDIO card supports 1 I/O functions
> mmc0: host does not support reading read-only switch. assuming write-enable.
> Restarting tasks... done
> mx27#
> mx27# echo mem > /sys/power/state
> Stopping tasks: ===============|
> Suspending console(s)
> <from here on the mx27 is dead>
>
>
> Regards,
> peter
>
>
>
> _______________________________________________
> LTIB home page: http://bitshrine.org
>
> Ltib mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/ltib