[Ltib] LTIB 8.1.2 ignores the kernel configuration request

[Thierry Pierret]

Hi,

I'm using LTIB on my i686 laptop under
Ubuntu 8.10 (GNU/Linux 2-6.27-8-genberic) to create an image for armv6l
iMX31 3-Stack platform. This image is based on the 2.6.24 Linux kernel.

I recently updated LTIB from the 7.4.1
version to the 8.1.2 version (actually, this was a new installation). Since
then, even if I check the "Configure the kernel" box, the kernel
menuconfig is not started at all.

Here are the first output lines of a
configuration  :

$ ./ltib -c
+ [ -n config/platform/imx/imx31_3stack.cf
-a ! -f config/platform/imx/.config ]
+ [ -n  ]
+ cd config/platform/imx
+ mconf main.lkc
../../userspace/packages.lkc:6: can't
open file "fsl_mm.lkc"
#
# using defaults found in .config
#


*** End of configuration.
*** Check the top-level Makefile for
additional configuration options.

+ cp .config defconfig.dev

Processing platform: Freescale iMX31
3-Stack Board
====================================================
using config/platform/imx/.config
PKG_CSR_WIFI_SRC in config/platform/imx/pkg_map
is not selectable
PKG_FSL_GUI_IMX35 in config/platform/imx/pkg_map
is not selectable
PKG_FSL_GUI_IMX37 in config/platform/imx/pkg_map
is not selectable
PKG_MBX_SRC in config/platform/imx/pkg_map
is not selectable

Processing: fake-provides
===========================

Processing: kernel
====================

Processing: skell
===================

....


Could this error about the "fsl_mm.lkc"
file be the cause of this ?
What have I done wrong ?

Thanks in advance for your support.
Regards.

Thierry Pierret