RE: [Ltib] Ltib Build failed for texinfo

[Nirmala]

Hi Fabio,
   The entries you have mentioned are already present in the pkg_map at
line 12 (busybox) 13 (distcc) 14 (ccache).



Thank you
Nirmala

On Tue, 2009-05-05 at 13:45 -0300, Estevam Fabio-R49496 wrote:
> Nirmala wrote:
> > Hi
> >   Trying to install ltib for Linux version 2.6.18 Before installing
> > ltib (using ./ltib), verified and installed all the necessary tools
> > listed at (What is required on your host before installing LTIB at
> > http://www.bitshrine.org/autodocs/LtibFaq.html#ref_1)   
> > 
> > 
> > But the ltib build failed, below is the error log  snippet:
> > ---------------------------------------------------------------------
> > 
> > make  all-recursive
> > make[1]: Entering directory `/opt/ltib/usr/src/rpm/BUILD/texinfo-4.8'
> > Making all in tools
> > make[2]: Entering directory
> > `/opt/ltib/usr/src/rpm/BUILD/texinfo-4.8/tools'
> > make[2]: *** No rule to make target `all'.  Stop.
> > make[2]: Leaving directory
> > `/opt/ltib/usr/src/rpm/BUILD/texinfo-4.8/tools'
> > make[1]: *** [all-recursive] Error 1
> > make[1]: Leaving directory `/opt/ltib/usr/src/rpm/BUILD/texinfo-4.8'
> > make: *** [all] Error 2
> > error: Bad exit status from /home/edgedeveloper/ltib/tmp/rpm-tmp.6956
> > (% 
> > build)
> > 
> > 
> > RPM build errors:
> >     Bad exit status from /home/edgedeveloper/ltib/tmp/rpm-tmp.6956 (%
> > build)
> > Build time for texinfo: 17 seconds
> > 
> > Failed building texinfo
> > Died at ./ltib line 1377.
> > traceback:
> >  main::build_host_rpms:1377
> >   main::host_checks:1432
> >    main:539
> > 
> > 
> > Started: Tue May  5 11:01:33 2009
> > Ended:   Tue May  5 11:01:51 2009
> > Elapsed: 18 seconds
> > 
> > These packages failed to build:
> > texinfo
> > 
> > Build Failed
> 
> I have a colleague that have had the same issue you describe.
> 
> This is what he did to fix it:
> 
> "This is the exact fail I had, so the fix is to modify
> ltib/config/userspace/pkg_map
> 
> Look for the lines -
> 
> PKG_DISTCC = distcc
> PKG_CCACHE = ccache
> 
> Lines 228 and 229 in my release. Cut and past them to a new position
> directly below -
> 
> PKG_BUSYBOX = busybox
> 
> Which should be line 12, this was all I had to do. "
> 
> Regards,
> 
> Fabio Estevam
>