Re: [Ltib] libXt "failed dependencies"

[Alan Carvalho de Assis]

Hi Stuart,

On 7/14/09, Stuart Hughes <address@hidden> wrote:
>
> In your previous email, the install was failing as these dependencies
> were not met:
>
> error: failed dependencies:
>       libc.so.6(GLIBC_2.0)   is needed by libXt-1.0.4-5
>       libc.so.6(GLIBC_2.1)   is needed by libXt-1.0.4-5
>
>
> However, your base_libs are only providing 2.4/2.5/private.  That looks
> a bit suspect, I normally get a load more (including 2.0/2.1).
>
> Which BSP are you working on and which toolchain  does it select (maybe
> you can attached your platforms .config).
>

I am not using a FSL BSP, I am using the most updated LTIB from CVS.

> You could try running ./ltib -p base_libs -f and then re-check what it
> provides.  The dependency in Xt looks reasonable to me.
>

Even after running "./ltib -p base_libs -f" it is only providing GLIBC
2.4 and 2.5.

To verify/confirm this issue I installed Ubuntu 9.04 into a virtual
machine and the same problem happened.

You can reproduce this problem this way:

1) Use a new and clean Linux machine (ie. Ubuntu 9.04)

2) Install needed LTIB dependency:
http://www.imxdev.org/wiki/index.php?title=ALL_Boards_ltib_config_ubuntu

3) Run ./ltib and select i.MX27ADS

4) Unselect Qtopia

5) Go ahead and wait few minutes until the error happen

Regards,

Alan