[Ltib] Qtopia

[Chris Westervelt]

Kevin,

 

We are able to build Qtopia and start it.  However, even with the patches to the spec for mouse and touch and trying every permutation of inclusion of the two in the configuration, I cannot do a calibration of the touch or use it in Qtoipia.  I cannot get a mouse to work either so basically it is stuck at the opening screen waiting for a tap on the screen.  I also followed the instructions on imxdev.org for startup which included

 

1.  export TSLIB_TSDEVICE=/dev/input/event1

2.  cat /dev/input/<supposed device> (only works for /dev/input/mice either touch screen or USB mouse)

3.       ts_calibrate.  (kind of hangs up and doesn’t do anything)

 

Any ideas?

 

Also, and somewhat exclusive, have you been able to run X11?  I get error messages back about finding the device.  Again, I followed the instructions in imxdev.org.

 

Chris Westervelt

Senior Product Development Engineer

Infrasafe, Inc.
12612 Challenger Pkwy
Suite 300
Orlando, FL
32826

http://www.infrasafe.com
Office:   (407) 926-6983

Mobile: (407) 595-7023       
Fax:    (407) 857-1635
Notice of Confidentiality:
This e-mail communication and the attachments hereto, if any, are intended solely for the information and use of the addressee(s) identified above and may contain information which is legally privileged and/or otherwise confidential. If a recipient of this e-mail communication is not an addressee (or an authorized representative of an addressee), such recipient is hereby advised that any review, disclosure, reproduction, re-transmission or other dissemination or use of this e-mail communication (or any information contained herein) is strictly prohibited. If you are not an addressee and have received this e-mail communication in error, please advise the sender of that circumstance either by reply e-mail or by telephone at (800) 238-2686, immediately delete this e-mail communication from any computer and destroy all physical copies of same.