[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: LYNX-DEV ver

From: T.E.Dickey
Subject: Re: LYNX-DEV ver
Date: Tue, 8 Apr 1997 19:05:28 -0400 (EDT)

> address@hidden (Robert Wilkens) wrote:
> >FYI: The release I'm using is 2.7.1.
>       Then it's puzzling why that ifdefing isn't getting NGROUPS
> defined.  In the worst case, it should end up defined arbitrarily
> to 32.  You can try adding -DNGROUPS=# in your SITE_LYDEFS for the
> top-level Makefile, where # is the value in your limits.h.
>       Perhaps Tom Dickey, who's been developing an autoconf for
> Lynx, has some thoughts on the matter.
Not really - I did a grep to see if there was any place that NGROUPS would
be used out of order, found none (though I see that solaris2 uses a value
of 16, so I made a note to construct a test for this).

-- but that's looking at the development version (I'll check on 2.7.1).

Thomas E. Dickey
; To UNSUBSCRIBE:  Send a mail message to address@hidden
;                  with "unsubscribe lynx-dev" (without the
;                  quotation marks) on a line by itself.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]