[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Octave-bug-tracker] [bug #54796] Consecutive plots drift out of the fig

From: Pantxo Diribarne
Subject: [Octave-bug-tracker] [bug #54796] Consecutive plots drift out of the figure area
Date: Sun, 7 Oct 2018 05:14:25 -0400 (EDT)
User-agent: Mozilla/5.0 (X11; Ubuntu; Linux x86_64; rv:62.0) Gecko/20100101 Firefox/62.0

Update of bug #54796 (project octave):

                Category:                Plotting => Plotting with OpenGL   
                  Status:            Works For Me => Fixed                  
             Open/Closed:                    Open => Closed                 


Follow-up Comment #3:

@Tunc: After looking again at Octave 4.2.2 I can confirm that I sometimes
observe a similar effect, one of the output png files is sometimes smaller
than expected (1167-by-875 instead of 1200-by-900 pixels) and the xlabel
partly goes outside the canvas. To trigger the bug I have to first switch to
fltk toolkit, draw a figure, switch back to Qt tookit and then run the
original snippet.

Anyway, even with the above procedure I still cannot reproduce the bug with
Octave 4.4.1 and dev. This is somewhat the same as what Rik observed in bug
#51829. As he said this bug seams to be gone in the current Octave version
(4.4.1), while it was present in previous versions including 4.2,  and I'll
close this report as fixed.


Reply to this item at:


  Message sent via Savannah

reply via email to

[Prev in Thread] Current Thread [Next in Thread]