|
From: | GARCIA ALVAREZ, ANA |
Subject: | [Paparazzi-devel] re:xbee pro xsc 900 |
Date: | Thu, 13 Jan 2011 08:52:05 +0100 |
Hi again, I have changed the baud rate to 57600. Now the gcs
populates(with waypoints and status). I have downlink but not datalink (I mean,
from gcs to autopilot). I had the same problem with the xbee pro 2.4ghz but it ran
when I set the destination address low to FFFF in the gcs module. I wonder if there is any special parameter with these xsc
900 which I should take care. David, do you use the sparkfun boards or any others? I am
now just thinking it could be related to the gcs board(where I have not removed
a diode, provided that I had to remove one in the on-air board). Does it make
sense? Do you use the transparent protocol? Thanks. |
[Prev in Thread] | Current Thread | [Next in Thread] |