[Qemu-arm] [PATCH 2/2] hw/arm/tosa: Fix reset handling

[Guenter Roeck]

Using the CPU reset handler for resets triggered by writing into
gpio pins other than GPIO01 is not appropriate and does not work,
since the reset triggered by writing into GPIO01 is configurable.
Use a separate reset handler for tosa to reset the entire system
and not just the CPU.

Signed-off-by: Guenter Roeck <address@hidden>
---
 hw/arm/tosa.c | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/hw/arm/tosa.c b/hw/arm/tosa.c
index 2db6650..1ee12f4 100644
--- a/hw/arm/tosa.c
+++ b/hw/arm/tosa.c
@@ -25,6 +25,7 @@
 #include "sysemu/block-backend.h"
 #include "hw/sysbus.h"
 #include "exec/address-spaces.h"
+#include "sysemu/sysemu.h"
 
 #define TOSA_RAM    0x04000000
 #define TOSA_ROM       0x00800000
@@ -86,6 +87,12 @@ static void tosa_out_switch(void *opaque, int line, int 
level)
     }
 }
 
+static void tosa_reset(void *opaque, int line, int level)
+{
+    if (level) {
+        qemu_system_reset_request();
+    }
+}
 
 static void tosa_gpio_setup(PXA2xxState *cpu,
                 DeviceState *scp0,
@@ -93,13 +100,16 @@ static void tosa_gpio_setup(PXA2xxState *cpu,
                 TC6393xbState *tmio)
 {
     qemu_irq *outsignals = qemu_allocate_irqs(tosa_out_switch, cpu, 4);
+    qemu_irq reset;
+
     /* MMC/SD host */
     pxa2xx_mmci_handlers(cpu->mmc,
                     qdev_get_gpio_in(scp0, TOSA_GPIO_SD_WP),
                     qemu_irq_invert(qdev_get_gpio_in(cpu->gpio, 
TOSA_GPIO_nSD_DETECT)));
 
     /* Handle reset */
-    qdev_connect_gpio_out(cpu->gpio, TOSA_GPIO_ON_RESET, cpu->reset);
+    reset = qemu_allocate_irq(tosa_reset, cpu, 0);
+    qdev_connect_gpio_out(cpu->gpio, TOSA_GPIO_ON_RESET, reset);
 
     /* PCMCIA signals: card's IRQ and Card-Detect */
     pxa2xx_pcmcia_set_irq_cb(cpu->pcmcia[0],
-- 
2.5.0