Re: [Qemu-arm] [Qemu-devel] VCPU hotplug on KVM/ARM

[Igor Mammedov]

On Tue, 27 Feb 2018 14:21:31 +0100
Andrew Jones <address@hidden> wrote:

> On Tue, Feb 27, 2018 at 01:46:04PM +0100, Christoffer Dall wrote:
> > On Tue, Feb 27, 2018 at 05:34:28PM +0530, address@hidden wrote:  
> > > Hi Christoffer,
> > > 
> > > Thanks for your reply.
> > > 
> > > On 2018-02-27 16:17, Christoffer Dall wrote:  
> > > >Hi Bhupinder,
> > > >
> > > >On Tue, Feb 27, 2018 at 03:01:17PM +0530, address@hidden wrote:  
> > > >>I hope it is the right forum to post my query.
> > > >>
> > > >>
> > > >>
> > > >>I am currently looking at the possibility of adding a new VCPU to a
> > > >>running
> > > >>guest VM in KVM/ARM. I see that currently, it is not allowed to add a
> > > >>new
> > > >>VCPU to a guest VM, if it is already initialized. The first check in
> > > >>kvm_arch_vcpu_create() returns failure if it is already initialized.
> > > >>  
> > > >
> > > >This would require a major rework of a lot of logic surrounding the GIC
> > > >and other parts of KVM initialization.
> > > >  
> > > >>
> > > >>
> > > >>There was some work done in QEMU to add support for VCPU hotplug:
> > > >>https://lists.gnu.org/archive/html/qemu-arm/2017-05/msg00404.html
> > > >>
> > > >>
> > > >>
> > > >>But I am looking at the KVM side for enabling adding a new VCPU. If you
> > > >>can
> > > >>point me to any relevant work/resources, which I can refer to then it
> > > >>will
> > > >>help me.
> > > >>  
> > > >
> > > >I don't have any specific pointers, but I was always told that the way
> > > >we were going to do CPU hotplug would be to instantiate a large number
> > > >of VCPUs, and hotplug would be equivalent to turning on a VCPU which was
> > > >previously powered off.
> > > >
> > > >Is this not still a feasible solution?  
> > > It should be a feasible solution provided the guest VM is not able to
> > > control the onlining/offlining of VCPUs. It should be controlled by the
> > > Host.
> > >   
> > 
> > KVM could simply refuse to turn on some of the CPUs unless given
> > permission from host userspace.
> >   
> > > >
> > > >How does VCPU hotplug work on x86?  
> > > On x86, you can add a vcpu through libvirt setvcpu command and it shows up
> > > in the guest VM as a new CPU if you do lscpu.
> > >   
> > 
> > Sure, but what is the mechanism, does x86 qemu actually call
> > KVM_CREATE_VCPU, or is this also a question of turning on already
> > created vcpus ?
In QEMU on x86 (and I think ppc, s390 as well), we create vCPUs on demand.

It would be nice if ARM would be able to do that too,
so that it could take advantage of the same code.

 
> CC'ing Igor and qemu-devel
> 
> drew
>