Re: [Qemu-arm] [PATCH v2 0/2] arm: Stub out NRF51 TWI magnetometer/accelerometer detection

[Peter Maydell]

On Thu, 10 Jan 2019 at 09:40, Stefan Hajnoczi <address@hidden> wrote:
>
> v2:
>  * Move stub code into a separate device [Peter]
>  * Instantiate stub from microbit board instead of nRF51 SoC since this is
>    microbit-specific.  Other boards using the nRF51 wouldn't necessarily want
>    to see these TWI/I2C devices.
>  * Add test case
>
> This series stubs out the microbit's TWI/I2C devices so the microbit-dal
> firmware boots successfully.  The accelerometer and magnetometer are probed at
> startup.  If they are not found the firmware panics.
>
> Stefan Hajnoczi (1):
>   tests/microbit-test: add TWI stub device test
>
> Steffen Görtz (1):
>   arm: Stub out NRF51 TWI magnetometer/accelerometer detection
>
>  hw/i2c/Makefile.objs          |   1 +
>  include/hw/arm/nrf51.h        |   2 +
>  include/hw/arm/nrf51_soc.h    |   1 +
>  include/hw/i2c/microbit_i2c.h |  42 +++++++++++
>  hw/arm/microbit.c             |  15 ++++
>  hw/i2c/microbit_i2c.c         | 127 ++++++++++++++++++++++++++++++++++
>  tests/microbit-test.c         |  44 ++++++++++++
>  7 files changed, 232 insertions(+)
>  create mode 100644 include/hw/i2c/microbit_i2c.h
>  create mode 100644 hw/i2c/microbit_i2c.c

Applied to target-arm.next, thanks. Can you provide a
MAINTAINERS file update for the new files, please?
(You can send that separately or stick it in another
nrf51 series if you're sending one.)

thanks
-- PMM