qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PATCH 2/7] qemu: make default_write_config use mask table


From: Isaku Yamahata
Subject: [Qemu-devel] [PATCH 2/7] qemu: make default_write_config use mask table
Date: Tue, 2 Jun 2009 15:42:45 +0900

From: Michael S. Tsirkin <address@hidden>

Change much of hw/pci to use symbolic constants and a table-driven
design: add a mask table with writable bits set and readonly bits unset.
Detect change by comparing original and new registers.

As a result, writing a single byte in BAR registers now works as it
should. Writing to upper limit registers in the bridge also works as it
should. Writes to BAR registers trigger mapping update.  Code is also
shorter.

Signed-off-by: Michael S. Tsirkin <address@hidden>
---
Changelog since v1
- simplify the code some more
- use PCI_CONFIG_SPACE_SIZE instead of 0x100
- only trigger pci update when IO/MEM bits in command register have changed
---
 hw/pci.c |  145 ++++++++++++-------------------------------------------------
 hw/pci.h |   18 +++++++-
 2 files changed, 46 insertions(+), 117 deletions(-)

diff --git a/hw/pci.c b/hw/pci.c
index 0ab5b94..1e70e46 100644
--- a/hw/pci.c
+++ b/hw/pci.c
@@ -239,6 +239,17 @@ int pci_assign_devaddr(const char *addr, int *domp, int 
*busp, unsigned *slotp)
     return pci_parse_devaddr(devaddr, domp, busp, slotp);
 }
 
+static void pci_init_mask(PCIDevice *dev)
+{
+    int i;
+    dev->mask[PCI_CACHE_LINE_SIZE] = 0xff;
+    dev->mask[PCI_INTERRUPT_LINE] = 0xff;
+    dev->mask[PCI_COMMAND] = PCI_COMMAND_IO | PCI_COMMAND_MEMORY
+                             | PCI_COMMAND_MASTER;
+    for (i = PCI_CONFIG_HEADER_SIZE; i < PCI_CONFIG_SPACE_SIZE; ++i)
+        dev->mask[i] = 0xff;
+}
+
 /* -1 for devfn means auto assign */
 static PCIDevice *do_pci_register_device(PCIDevice *pci_dev, PCIBus *bus,
                                          const char *name, int devfn,
@@ -261,6 +272,7 @@ static PCIDevice *do_pci_register_device(PCIDevice 
*pci_dev, PCIBus *bus,
     pstrcpy(pci_dev->name, sizeof(pci_dev->name), name);
     memset(pci_dev->irq_state, 0, sizeof(pci_dev->irq_state));
     pci_set_default_subsystem_id(pci_dev);
+    pci_init_mask(pci_dev);
 
     if (!config_read)
         config_read = pci_default_read_config;
@@ -334,6 +346,7 @@ void pci_register_io_region(PCIDevice *pci_dev, int 
region_num,
 {
     PCIIORegion *r;
     uint32_t addr;
+    uint32_t mask;
 
     if ((unsigned int)region_num >= PCI_NUM_REGIONS)
         return;
@@ -349,12 +362,17 @@ void pci_register_io_region(PCIDevice *pci_dev, int 
region_num,
     r->size = size;
     r->type = type;
     r->map_func = map_func;
+
+    mask = ~(size - 1);
     if (region_num == PCI_ROM_SLOT) {
         addr = 0x30;
+        /* ROM enable bit is writeable */
+        mask |= 1;
     } else {
         addr = 0x10 + region_num * 4;
     }
     *(uint32_t *)(pci_dev->config + addr) = cpu_to_le32(type);
+    *(uint32_t *)(pci_dev->mask + addr) = cpu_to_le32(mask);
 }
 
 static void pci_update_mappings(PCIDevice *d)
@@ -463,118 +481,21 @@ uint32_t pci_default_read_config(PCIDevice *d,
     return val;
 }
 
-void pci_default_write_config(PCIDevice *d,
-                              uint32_t address, uint32_t val, int len)
+void pci_default_write_config(PCIDevice *d, uint32_t addr, uint32_t val, int l)
 {
-    int can_write, i;
-    uint32_t end, addr;
-
-    if (len == 4 && ((address >= 0x10 && address < 0x10 + 4 * 6) ||
-                     (address >= 0x30 && address < 0x34))) {
-        PCIIORegion *r;
-        int reg;
+    uint8_t orig[PCI_CONFIG_SPACE_SIZE];
+    int i;
 
-        if ( address >= 0x30 ) {
-            reg = PCI_ROM_SLOT;
-        }else{
-            reg = (address - 0x10) >> 2;
-        }
-        r = &d->io_regions[reg];
-        if (r->size == 0)
-            goto default_config;
-        /* compute the stored value */
-        if (reg == PCI_ROM_SLOT) {
-            /* keep ROM enable bit */
-            val &= (~(r->size - 1)) | 1;
-        } else {
-            val &= ~(r->size - 1);
-            val |= r->type;
-        }
-        *(uint32_t *)(d->config + address) = cpu_to_le32(val);
-        pci_update_mappings(d);
-        return;
-    }
- default_config:
     /* not efficient, but simple */
-    addr = address;
-    for(i = 0; i < len; i++) {
-        /* default read/write accesses */
-        switch(d->config[0x0e]) {
-        case 0x00:
-        case 0x80:
-            switch(addr) {
-            case 0x00:
-            case 0x01:
-            case 0x02:
-            case 0x03:
-            case 0x06:
-            case 0x07:
-            case 0x08:
-            case 0x09:
-            case 0x0a:
-            case 0x0b:
-            case 0x0e:
-            case 0x10 ... 0x27: /* base */
-            case 0x2c ... 0x2f: /* read-only subsystem ID & vendor ID */
-            case 0x30 ... 0x33: /* rom */
-            case 0x3d:
-                can_write = 0;
-                break;
-            default:
-                can_write = 1;
-                break;
-            }
-            break;
-        default:
-        case 0x01:
-            switch(addr) {
-            case 0x00:
-            case 0x01:
-            case 0x02:
-            case 0x03:
-            case 0x06:
-            case 0x07:
-            case 0x08:
-            case 0x09:
-            case 0x0a:
-            case 0x0b:
-            case 0x0e:
-            case 0x2c ... 0x2f: /* read-only subsystem ID & vendor ID */
-            case 0x38 ... 0x3b: /* rom */
-            case 0x3d:
-                can_write = 0;
-                break;
-            default:
-                can_write = 1;
-                break;
-            }
-            break;
-        }
-        if (can_write) {
-            /* Mask out writes to reserved bits in registers */
-            switch (addr) {
-           case 0x05:
-                val &= ~PCI_COMMAND_RESERVED_MASK_HI;
-                break;
-            case 0x06:
-                val &= ~PCI_STATUS_RESERVED_MASK_LO;
-                break;
-            case 0x07:
-                val &= ~PCI_STATUS_RESERVED_MASK_HI;
-                break;
-            }
-            d->config[addr] = val;
-        }
-        if (++addr > 0xff)
-               break;
-        val >>= 8;
+    memcpy(orig, d->config, PCI_CONFIG_SPACE_SIZE);
+    for(i = 0; i < l && addr < PCI_CONFIG_SPACE_SIZE; val >>= 8, ++i, ++addr) {
+        uint8_t mask = d->mask[addr];
+        d->config[addr] = (d->config[addr] & ~mask) | (val & mask);
     }
-
-    end = address + len;
-    if (end > PCI_COMMAND && address < (PCI_COMMAND + 2)) {
-        /* if the command register is modified, we must modify the mappings */
+    if (memcmp(orig + PCI_BASE_ADDRESS_0, d->config + PCI_BASE_ADDRESS_0, 24)
+        || ((orig[PCI_COMMAND] ^ d->config[PCI_COMMAND])
+            & (PCI_COMMAND_MEMORY | PCI_COMMAND_IO)))
         pci_update_mappings(d);
-    }
 }
 
 void pci_data_write(void *opaque, uint32_t addr, uint32_t val, int len)
@@ -847,16 +768,8 @@ static void pci_bridge_write_config(PCIDevice *d,
 {
     PCIBridge *s = (PCIBridge *)d;
 
-    if (address == 0x19 || (address == 0x18 && len > 1)) {
-        if (address == 0x19)
-            s->bus->bus_num = val & 0xff;
-        else
-            s->bus->bus_num = (val >> 8) & 0xff;
-#if defined(DEBUG_PCI)
-        printf ("pci-bridge: %s: Assigned bus %d\n", d->name, s->bus->bus_num);
-#endif
-    }
     pci_default_write_config(d, address, val, len);
+    s->bus->bus_num = d->config[PCI_SECONDARY_BUS];
 }
 
 PCIBus *pci_find_bus(int bus_num)
diff --git a/hw/pci.h b/hw/pci.h
index 0405837..c0c2380 100644
--- a/hw/pci.h
+++ b/hw/pci.h
@@ -100,16 +100,24 @@ typedef struct PCIIORegion {
 #define PCI_COMMAND            0x04    /* 16 bits */
 #define  PCI_COMMAND_IO                0x1     /* Enable response in I/O space 
*/
 #define  PCI_COMMAND_MEMORY    0x2     /* Enable response in Memory space */
+#define  PCI_COMMAND_MASTER    0x4     /* Enable bus master */
 #define PCI_STATUS              0x06    /* 16 bits */
 #define PCI_REVISION_ID         0x08    /* 8 bits  */
 #define PCI_CLASS_DEVICE        0x0a    /* Device class */
+#define PCI_CACHE_LINE_SIZE    0x0c    /* 8 bits */
+#define PCI_LATENCY_TIMER      0x0d    /* 8 bits */
 #define PCI_HEADER_TYPE         0x0e    /* 8 bits */
 #define  PCI_HEADER_TYPE_NORMAL                0
 #define  PCI_HEADER_TYPE_BRIDGE                1
 #define  PCI_HEADER_TYPE_CARDBUS       2
 #define  PCI_HEADER_TYPE_MULTI_FUNCTION 0x80
+#define PCI_BASE_ADDRESS_0     0x10    /* 32 bits */
+#define PCI_PRIMARY_BUS                0x18    /* Primary bus number */
+#define PCI_SECONDARY_BUS      0x19    /* Secondary bus number */
+#define PCI_SEC_STATUS         0x1e    /* Secondary status register, only bit 
14 used */
 #define PCI_SUBSYSTEM_VENDOR_ID 0x2c    /* 16 bits */
 #define PCI_SUBSYSTEM_ID        0x2e    /* 16 bits */
+#define PCI_CAPABILITY_LIST    0x34    /* Offset of first capability list 
entry */
 #define PCI_INTERRUPT_LINE     0x3c    /* 8 bits */
 #define PCI_INTERRUPT_PIN      0x3d    /* 8 bits */
 #define PCI_MIN_GNT            0x3e    /* 8 bits */
@@ -139,10 +147,18 @@ typedef struct PCIIORegion {
 
 #define PCI_COMMAND_RESERVED_MASK_HI (PCI_COMMAND_RESERVED >> 8)
 
+/* Size of the standard PCI config header */
+#define PCI_CONFIG_HEADER_SIZE 0x40
+/* Size of the standard PCI config space */
+#define PCI_CONFIG_SPACE_SIZE 0x100
+
 struct PCIDevice {
     DeviceState qdev;
     /* PCI config space */
-    uint8_t config[256];
+    uint8_t config[PCI_CONFIG_SPACE_SIZE];
+
+    /* Used to implement R/W bytes */
+    uint8_t mask[PCI_CONFIG_SPACE_SIZE];
 
     /* the following fields are read only */
     PCIBus *bus;
-- 
1.6.0.2





reply via email to

[Prev in Thread] Current Thread [Next in Thread]