qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PATCH 0/3] omap_gpio: convert to qdev


From: Peter Maydell
Subject: [Qemu-devel] [PATCH 0/3] omap_gpio: convert to qdev
Date: Wed, 29 Jun 2011 19:53:08 +0100

These patches are changes from the meego omap3 tree which convert
the omap GPIO module device to use qdev.

My general plan for landing the omap3 changes is to start by peeling
off reasonably independent chunks which can be presented as fixes
or cleanups to the existing omap1/omap2 code, and this is the first
of those. Once I run out of those the core "add omap3" patchset should
be much smaller and more manageable...

Sorry patch 3 is so large; I couldn't see anything more that I could
pull out as a separate patch.

(The Signed-off-by lines are a bit convoluted but so is the history
of the patchset; I hope and believe they're satisfactory to all the
participants.)

Juha Riihimäki (2):
  hw/omap_l4.c: Add helper function omap_l4_base
  hw/omap_gpio.c: Convert to qdev

Peter Maydell (1):
  hw/omap_gpio.c: Don't complain about some writes to r/o registers

 hw/nseries.c   |   47 +++++------
 hw/omap.h      |   21 +-----
 hw/omap1.c     |   10 ++-
 hw/omap2.c     |   26 ++++--
 hw/omap_gpio.c |  248 +++++++++++++++++++++++++++----------------------------
 hw/omap_l4.c   |    5 +
 hw/palm.c      |   26 +++---
 7 files changed, 189 insertions(+), 194 deletions(-)




reply via email to

[Prev in Thread] Current Thread [Next in Thread]