[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH 2/2] device_isolation: Support isolation on POWE
From: |
Michael Ellerman |
Subject: |
Re: [Qemu-devel] [PATCH 2/2] device_isolation: Support isolation on POWER p7ioc (IODA) bridges |
Date: |
Thu, 15 Dec 2011 17:48:38 +1100 |
On Thu, 2011-12-15 at 17:08 +1100, David Gibson wrote:
> This patch adds code to the code for the powernv platform to create
> and populate isolation groups on hardware using the p7ioc (aka IODA) PCI host
> bridge used on some IBM POWER systems.
> diff --git a/arch/powerpc/platforms/powernv/pci-ioda.c
> b/arch/powerpc/platforms/powernv/pci-ioda.c
> index 0cdc8302..6df632e 100644
> --- a/arch/powerpc/platforms/powernv/pci-ioda.c
> +++ b/arch/powerpc/platforms/powernv/pci-ioda.c
> @@ -861,6 +862,9 @@ static void __devinit pnv_ioda_setup_bus_dma(struct
> pnv_ioda_pe *pe,
> set_iommu_table_base(&dev->dev, &pe->tce32_table);
> if (dev->subordinate)
> pnv_ioda_setup_bus_dma(pe, dev->subordinate);
> +#ifdef CONFIG_DEVICE_ISOLATION
> + device_isolation_dev_add(&pe->di_group, &dev->dev);
> +#endif
You already have a nop version of that in device_isolation.h, so the
ifdef is not required AFAICS.
And similarly elsewhere.
cheers
signature.asc
Description: This is a digitally signed message part