[Qemu-devel] [PATCH 11/18] ehci: fix reset

[Gerd Hoffmann]

Check for the reset bit first when processing USBCMD register writes.
Also break out of the switch, there is no need to check the other bits.

Signed-off-by: Gerd Hoffmann <address@hidden>
---
 hw/usb/hcd-ehci.c |   10 ++++++----
 1 files changed, 6 insertions(+), 4 deletions(-)

diff --git a/hw/usb/hcd-ehci.c b/hw/usb/hcd-ehci.c
index f8ed80d..3b602b0 100644
--- a/hw/usb/hcd-ehci.c
+++ b/hw/usb/hcd-ehci.c
@@ -1107,6 +1107,12 @@ static void ehci_mem_writel(void *ptr, 
target_phys_addr_t addr, uint32_t val)
     /* Do any register specific pre-write processing here.  */
     switch(addr) {
     case USBCMD:
+        if (val & USBCMD_HCRESET) {
+            ehci_reset(s);
+            val = s->usbcmd;
+            break;
+        }
+
         if ((val & USBCMD_RUNSTOP) && !(s->usbcmd & USBCMD_RUNSTOP)) {
             qemu_mod_timer(s->frame_timer, qemu_get_clock_ns(vm_clock));
             SET_LAST_RUN_CLOCK(s);
@@ -1121,10 +1127,6 @@ static void ehci_mem_writel(void *ptr, 
target_phys_addr_t addr, uint32_t val)
             ehci_set_usbsts(s, USBSTS_HALT);
         }
 
-        if (val & USBCMD_HCRESET) {
-            ehci_reset(s);
-            val = s->usbcmd;
-        }
 
         /* not supporting dynamic frame list size at the moment */
         if ((val & USBCMD_FLS) && !(s->usbcmd & USBCMD_FLS)) {
-- 
1.7.1