[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH] SCSI: STARTSTOPUNIT only eject/load media if po
From: |
ronnie sahlberg |
Subject: |
Re: [Qemu-devel] [PATCH] SCSI: STARTSTOPUNIT only eject/load media if powercondition is 0 |
Date: |
Mon, 30 Jul 2012 18:46:26 +1000 |
I will create a patch for ATAPI for this.
On Mon, Jul 30, 2012 at 6:20 PM, Kevin Wolf <address@hidden> wrote:
> Am 28.07.2012 03:14, schrieb Ronnie Sahlberg:
>> The START STOP UNIT command will only eject/load media if
>> power condition is zero.
>>
>> If power condition is !0 then LOEJ and START will be ignored.
>>
>> From MMC (sbc contains similar wordings too)
>> The Power Conditions field requests the block device to be placed
>> in the power condition defined in
>> Table 558. If this field has a value other than 0h then the Start
>> and LoEj bits shall be ignored.
>>
>> Signed-off-by: Ronnie Sahlberg <address@hidden>
>
> Does ATAPI need the same?
>
> Kevin