qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PATCH] hw/m25p80.c: add WRSR(0x01) support


From: Dante
Subject: [Qemu-devel] [PATCH] hw/m25p80.c: add WRSR(0x01) support
Date: Fri, 18 Jan 2013 14:17:11 +0800

Atmel, SST and Intel/Numonyx serial flash tend to power up
with the software protection bits set.
And thus the new m25p80.c in linux kernel would always tries
to use WREN(0x06) + WRSR(0x01) to turn-off the protection.
The WEL(0x02) of status register is supposed to be cleared
after WRSR(0x01).
There are some drivers (i.e my own tiny driver for RTOSes) would
check the WEL(0x02) in status register to make sure the protection
is correctly turned off, so this patch is mandatory to me.

Signed-off-by: Kuo-Jung Su <address@hidden>
---
 hw/m25p80.c |   16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/hw/m25p80.c b/hw/m25p80.c
index d392656..c8d0411 100644
--- a/hw/m25p80.c
+++ b/hw/m25p80.c
@@ -184,6 +184,7 @@ static const FlashPartInfo known_devices[] = {
 
 typedef enum {
     NOP = 0,
+    WRSR = 0x1,
     WRDI = 0x4,
     RDSR = 0x5,
     WREN = 0x6,
@@ -377,6 +378,12 @@ static void complete_collecting_data(Flash *s)
     case ERASE_SECTOR:
         flash_erase(s, s->cur_addr, s->cmd_in_progress);
         break;
+    case WRSR:
+       if (s->write_enable) {
+               s->state = STATE_IDLE;
+               s->write_enable = false;
+       }
+       break;
     default:
         break;
     }
@@ -440,6 +447,15 @@ static void decode_new_cmd(Flash *s, uint32_t value)
         s->len = 0;
         s->state = STATE_COLLECTING_DATA;
         break;
+        
+       case WRSR:
+               if (s->write_enable) {
+                       s->needed_bytes = 1;
+                       s->pos = 0;
+               s->len = 0;
+                       s->state = STATE_COLLECTING_DATA;
+               }
+        break;
 
     case WRDI:
         s->write_enable = false;
-- 
1.7.9.5


********************* Confidentiality Notice ************************
This electronic message and any attachments may contain
confidential and legally privileged information or
information which is otherwise protected from disclosure.
If you are not the intended recipient,please do not disclose
the contents, either in whole or in part, to anyone,and
immediately delete the message and any attachments from
your computer system and destroy all hard copies.
Thank you for your cooperation.
***********************************************************************




reply via email to

[Prev in Thread] Current Thread [Next in Thread]