[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH] ahci: set ahci mode on reset
From: |
Michael S. Tsirkin |
Subject: |
[Qemu-devel] [PATCH] ahci: set ahci mode on reset |
Date: |
Sun, 29 Sep 2013 00:09:35 +0300 |
ATM we set AHCI mode on 1st GHC write.
Spec says we should set it on reset.
Signed-off-by: Michael S. Tsirkin <address@hidden>
---
hw/ide/ahci.c | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/hw/ide/ahci.c b/hw/ide/ahci.c
index a71a4ca..a8be62c 100644
--- a/hw/ide/ahci.c
+++ b/hw/ide/ahci.c
@@ -1198,7 +1198,15 @@ void ahci_reset(AHCIState *s)
int i;
s->control_regs.irqstatus = 0;
- s->control_regs.ghc = 0;
+ /* AHCI Enable (AE)
+ * The implementation of this bit is dependent upon the value of the
+ * CAP.SAM bit. If CAP.SAM is '0', then GHC.AE shall be read-write and
+ * shall have a reset value of '0'. If CAP.SAM is '1', then AE shall be
+ * read-only and shall have a reset value of '1'.
+ *
+ * We set HOST_CAP_AHCI so we must enable AHCI at reset.
+ */
+ s->control_regs.ghc = HOST_CTL_AHCI_EN;
for (i = 0; i < s->ports; i++) {
pr = &s->dev[i].port_regs;
--
MST
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Qemu-devel] [PATCH] ahci: set ahci mode on reset,
Michael S. Tsirkin <=