Re: [Qemu-devel] [PATCH v3 6/8] hw: set interrupts using pci irq wrappers

[Marcel Apfelbaum]

> > >  static void uhci_reset(void *opaque)
> > > @@ -1240,8 +1239,7 @@ static int usb_uhci_common_initfn(PCIDevice *dev)
> > >      /* TODO: reset value should be 0. */
> > >      pci_conf[USB_SBRN] = USB_RELEASE_1; // release number
> > >  
> > > -    s->irq_pin = u->info.irq_pin;
> > > -    pci_config_set_interrupt_pin(pci_conf, s->irq_pin + 1);
> > > +    pci_config_set_interrupt_pin(pci_conf, u->info.irq_pin + 1);
> > 
> > So everyone does this + 1/ - 1 logic.
> > 
> > We get comments like:
> >     pci_config_set_interrupt_pin(pci_conf, 1); /* interrupt pin 0 */
> > which just shows the API is confusing.
> > How about we change pci_config_set_interrupt_pin to do + 1
> > internally?
> > Then add pci_config_get_interrupt_pin to do - 1.
It seems a good idea.  
> > 
> > Add a comment that this does not support devices without interrupts,
> > for that - use get_byte directly.
> 
> 
> Note: this is not a problem with your patch, it can
> be a cleanup on top.
> 
I will make another patch(not part of this series)
to be applied on top of this series.

Thanks,
Marcel