Re: [Qemu-devel] unable to auth to vnc with qemu 2.4.0-rc0

[Paolo Bonzini]

On 14/07/2015 13:58, Vasiliy Tolstov wrote:
> vncviewer can't auto to qemu vnc with plain auth:
> Client sock=23 ws=0 auth=2 subauth=0
> New client on socket 23
> vnc_set_share_mode/23: undefined -> connecting
> Write Plain: Pending output 0x7fc8eba5dbe0 size 1036 offset 12. Wait SSF 0
> Wrote wire 0x7fc8eba5dbe0 12 -> 12
> Read plain (nil) size 0 offset 0
> Read wire 0x7fc8eaec3890 4096 -> 12
> Client request protocol version 3.8
> Telling client we support auth 2
> Write Plain: Pending output 0x7fc8eba5dbe0 size 1036 offset 2. Wait SSF 0
> Wrote wire 0x7fc8eba5dbe0 2 -> 2
> Read plain 0x7fc8eaec3890 size 5120 offset 0
> Read wire 0x7fc8eaec3890 4096 -> 1
> Client requested auth 2
> Start VNC auth
> Write Plain: Pending output 0x7fc8eba5dbe0 size 1036 offset 16. Wait SSF 0
> Wrote wire 0x7fc8eba5dbe0 16 -> 16
> Read plain 0x7fc8eaec3890 size 5120 offset 0
> Read wire 0x7fc8eaec3890 4096 -> 16
> Client challenge response did not match
> Write Plain: Pending output 0x7fc8eba5dbe0 size 1036 offset 30. Wait SSF 0
> Wrote wire 0x7fc8eba5dbe0 30 -> 30
> Closing down client sock: protocol error
> vnc_set_share_mode/23: connecting -> disconnected

Can you send the config.log and config-host.mak file from the build
directory?

Paolo