Re: [Qemu-devel] [PATCH v14 0/8] i.MX: Add i.MX25 support through the PDK evaluation board

[Peter Maydell]

On 10 August 2015 at 23:02, Jean-Christophe Dubois <address@hidden> wrote:
> This series of patches is generated against Peter Maydell GIT tree:
> https://git.linaro.org/people/peter.maydell/qemu-arm.git
>   branch target-arm-post-2.4
>
> This series of patches add the support for the i.MX25 processor through the
> Freescale PDK evaluation board.
>
> For now a limited set of devices is supported.
>     * GPT timers (from i.MX31)
>     * EPIT timers (from i.MX31)
>     * Serial ports (from i.MX31)
>     * Ethernet FEC port
>     * I2C controller
>
> In the process the KZM platform was split into an i.MX31 SOC
> and a plateform part.
>
> Also, I2C devices was added to the i.MX31 SOC.
>
> This was tested by:
>     * booting a minimal linux system on the i.MX25 PDK platform
>     * booting the Xvisor hypervisor on the i.MX25 PDK platform
>     * booting a minimal linux system on the KZM platform
>
> Jean-Christophe Dubois (8):
>   i.MX: Add SOC support for i.MX31
>   i.MX: KZM now uses the standalone i.MX31 SOC support
>   i.MX: Add I2C controller emulator
>   i.MX: Add FEC Ethernet Emulator
>   i.MX: Add SOC support for i.MX25
>   i.MX: Add the i.MX25 PDK plateform
>   i.MX: Add qtest support for I2C device emulator.
>   i.MX: Add i2C devices to i.MX31 SOC

I think this series is OK content-wise, but checkpatch.pl produces
a lot of errors on most of these patches. Can you fix them,
please?

thanks
-- PMM