[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH v1 1/1] cadence_uart: Check baud rate generator and
From: |
Alistair Francis |
Subject: |
[Qemu-devel] [PATCH v1 1/1] cadence_uart: Check baud rate generator and divider values on migration |
Date: |
Fri, 4 Nov 2016 17:00:31 -0700 |
The Cadence UART device emulator calculates speed by dividing the
baud rate by a 'baud rate generator' & 'baud rate divider' value.
The device specification defines these register values to be
non-zero and within certain limits. Checks were recently added when
writing to these registers but not when restoring from migration.
This patch adds checks when restoring from migration to avoid divide by
zero errors.
Reported-by: Huawei PSIRT <address@hidden>
Signed-off-by: Alistair Francis <address@hidden>
---
hw/char/cadence_uart.c | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/hw/char/cadence_uart.c b/hw/char/cadence_uart.c
index def34cd..e3a6248 100644
--- a/hw/char/cadence_uart.c
+++ b/hw/char/cadence_uart.c
@@ -487,6 +487,19 @@ static int cadence_uart_post_load(void *opaque, int
version_id)
{
CadenceUARTState *s = opaque;
+ /* Ensure these two aren't invalid numbers */
+ if (s->r[R_BRGR] <= 1) {
+ /* Value is invalid, reset it */
+ s->r[R_BRGR] = 0x0000028B;
+ }
+ if (s->r[R_BDIV] <= 3) {
+ /* Value is invalid, reset it */
+ s->r[R_BDIV] = 0x0000000F;
+ }
+
+ s->r[R_BRGR] = s->r[R_BRGR] & 0xFFFF;
+ s->r[R_BDIV] = s->r[R_BDIV] & 0xFF;
+
uart_parameters_setup(s);
uart_update_status(s);
return 0;
--
2.7.4
- [Qemu-devel] [PATCH v1 1/1] cadence_uart: Check baud rate generator and divider values on migration,
Alistair Francis <=