qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [Qemu-ppc] [Bug 1674925] Re: Qemu PPC64 kvm no display


From: luigiburdo
Subject: Re: [Qemu-devel] [Qemu-ppc] [Bug 1674925] Re: Qemu PPC64 kvm no display if --device virtio-gpu-pci is selected
Date: Wed, 22 Mar 2017 14:25:25 -0000

Hi Thomas,

just exit like it is an error with a wrong option.
the output is only this   qemu-system-ppc64: KVM and IRQ_XICS capability must 
be present for in-kernel XICS
Same is if i add all the options i have the seme error.
look like qemu need for run in kvm  a  kernel with XICS option enabled and XICS 
 is present only from ibm power 5 to up if i remember good.
After work i can test it if needed on Qoriq e5500 too for check if there is the 
same issue on an emb ppc64 processor.

Ciao
Luigi


On 22.03.2017 14:35, luigiburdo wrote:
> Hi Thomas with 2.9 rc1 i have this with --enable-kvm
>
> emu-system-ppc64 --enable-kvm
> qemu-system-ppc64: KVM and IRQ_XICS capability must be present for in-kernel 
> XICS
>
> and the qemu dont run.

Does it exit, or just hang afterwards? Was this with or without --device
virtio-gpu-pci option? Do you get any output if you run QEMU with
"-nographic" instead?

 Thomas

-- 
You received this bug notification because you are a member of qemu-
devel-ml, which is subscribed to QEMU.
https://bugs.launchpad.net/bugs/1674925

Title:
  Qemu PPC64 kvm no display if  --device virtio-gpu-pci is selected

Status in QEMU:
  New

Bug description:
  Hi,
  i did many tests on qemu 2.8 on my BE machines and i found an issue that i 
think was need to be reported

  Test Machines BE 970MP

  if i setup qemu with

  qemu-system-ppc64 -M 1024 --display sdl(or gtk),gl=on --device virtio-
  gpu-pci,virgl --enable-kvm and so and so

  result is doubled window one is vga other is virtio-gpu-pci without
  any start of the VM . pratically i dont have any output of openbios
  and on the virtual serial output

  the same issue i found is if i select:
  qemu-system-ppc64 -M 1024 --display gtk(or sdl) --device virtio-gpu-pci 
--enable-kvm and so and so

  
  i had been try to change all the -M types of all kind of pseries without any 
positive result.

  Ciao 
  Luigi

To manage notifications about this bug go to:
https://bugs.launchpad.net/qemu/+bug/1674925/+subscriptions



reply via email to

[Prev in Thread] Current Thread [Next in Thread]