Re: [Qemu-devel] [PATCH v7 00/13] Add support for the ZynqMP Generic QSPI

[Alistair Francis]

On Tue, Nov 21, 2017 at 10:39 AM, Peter Maydell
<address@hidden> wrote:
> On 3 November 2017 at 00:00, Francisco Iglesias
> <address@hidden> wrote:
>> Hi,
>>
>> This patch series is an attempt to add support for the ZynqMP QSPI 
>> (consisting
>> of the Generic QSPI and the legacy QSPI) to the xlnx-zcu102 board and connect
>> Numonyx n25q512a11 flashes to the QSPI. Also some functionality is added to
>> m25p80.
>>
>> The series starts by adding support in m25p80 for continous read out of 
>> status
>> registers, SST flash READ ID commands, bank address register accesses, bulk
>> erase (0x60) and two Numonyx flashes (n25q512a11 and n25q512a13). Thereafter 
>> it
>> updates the striping behaviour to be bit big endiann in the Xilinx QSPI model
>> and adds support for RX discard, zero pumping according transfer register 
>> and 4
>> byte LQSPI addresses. Finally it adds support for the ZynqMP Generic QSPI and
>> adds the ZynqMP QSPI to the xlnx-zcu102 board.
>>
>> Best regards,
>> Francisco Iglesias
>
> Hi; just a note to say that I'm assuming the Xilinx folk are going
> to review the xilinx_spips patches in this set...

Yep, we will!

Alistair

>
> thanks
> -- PMM
>