qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [RFC] Defining firmware (OVMF, et al) metadata format &


From: Eric Blake
Subject: Re: [Qemu-devel] [RFC] Defining firmware (OVMF, et al) metadata format & file
Date: Fri, 6 Apr 2018 13:10:00 -0500
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:52.0) Gecko/20100101 Thunderbird/52.7.0

On 04/06/2018 12:28 PM, Laszlo Ersek wrote:

> I've created an RFC-level "qapi/firmware.json" schema file, based on
> this discussion. It "builds", and the generated documentation looks
> acceptable, superficially speaking.
> 
> Before I post "qapi/firmware.json" for getting comments, I'd like to
> write JSON text that (a) describes firmware that I use, and (b) conforms
> to the schema. IOW, I'd like to validate whether the schema is good
> enough for describing at least such firmware that I know.
> 
> Is there a tool that generates example JSON objects from a given schema?

I know the QMP shell (scripts/qmp/qmp-shell) lets you enter commands
with a lot less typing than full JSON, and has a mode where it will then
echo the full JSON command it constructed from what you typed.  To be
able to quickly validate examples, it may be sufficient to temporarily
add a new QMP command 'check-firmware':

{ 'command': 'check-firmware', 'boxed': true, 'data': 'Firmware' }

assuming 'Firmware' is your top-level 'struct' in the QAPI file, then
implement a trivial:

qmp_check_firmware(Firmware *obj, Error **errp) {
    return 0;
}

so that you can then run QMP shell, and type:

check-firmware arg1=foo arg2=bar ...

which will then generate the corresponding JSON, then either
successfully do nothing (what you typed validated, AND you have the JSON
output printed), or print an error (what you typed failed QAPI
validation, perhaps because it had an unrecognized key, was missing a
required key, used a wrong type, etc).

> I vaguely recall there used to be one. Otherwise, writing the examples
> manually looks arduous (and I wouldn't know how to verify them against
> the schema).

Similarly, if you generate a command the produces a 'Firmware' as the
return value, then you can populate the generated C struct (since you
did manage to run the QAPI generator over your new file, you should be
able to look at the C struct it generated), then output that over QMP to
show the counterpart JSON that matches the struct as populated.

-- 
Eric Blake, Principal Software Engineer
Red Hat, Inc.           +1-919-301-3266
Virtualization:  qemu.org | libvirt.org

Attachment: signature.asc
Description: OpenPGP digital signature


reply via email to

[Prev in Thread] Current Thread [Next in Thread]