qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [RFC][BROKEN] rbd: Allow configuration of authenticatio


From: Daniel P . Berrangé
Subject: Re: [Qemu-devel] [RFC][BROKEN] rbd: Allow configuration of authentication scheme
Date: Wed, 18 Apr 2018 18:04:57 +0100
User-agent: Mutt/1.9.2 (2017-12-15)

On Wed, Apr 18, 2018 at 06:52:08PM +0200, Kevin Wolf wrote:
> Am 18.04.2018 um 18:34 hat Daniel P. Berrangé geschrieben:
> > On Wed, Apr 18, 2018 at 06:28:23PM +0200, Kevin Wolf wrote:
> > > Am 18.04.2018 um 17:06 hat Markus Armbruster geschrieben:
> > 
> > > >     Note that users can still configure authentication methods with a
> > > >     configuration file.  They probably do that anyway if they use Ceph
> > > >     outside QEMU as well.
> > > 
> > > This solution that we originally intended to offer was dismissed by
> > > libvirt as unpractical: libvirt allows the user to specify both a config
> > > file and a key, and if it wanted to use a config file to pass the key,
> > > it would have to create a merged config file and keep it sync with the
> > > user config file at all times. Understandable that they want to avoid
> > > this.
> > 
> > Even if the config file does have auth info setup, we can't assume that
> > the QEMU VMs are supposed to use the same auth info. In fact to properly
> > protect against compromised QEMU, ideally every QEMU would use a completely
> > separate RBD user+password, so that compromised QEMU can't then access
> > RBD disks belonging to a different user.
> > 
> > So from libvirt POV we want to pretend the config file does not exist at
> > all and explicitly pass everything that is needed via normal per-disk
> > setup for blockdev.
> 
> From the rbd driver:
> 
>  * The "conf" option specifies a Ceph configuration file to read.  If
>  * it is not specified, we will read from the default Ceph locations
>  * (e.g., /etc/ceph/ceph.conf).  To avoid reading _any_ configuration
>  * file, specify conf=/dev/null.
> 
> So what we actually expected libvirt to do is to create a config file
> for each rbd image and pass that to qemu. However, libvirt allows the
> user to specify their own config file and passes that, and therefore
> doesn't want to create its own config file. If the user doesn't specify
> a config file, libvirt should probably indeed use /dev/null at least.

Yeah this is a mess - I wish we had never allowed users to pass a config
file, and had used /dev/null all the time. Unfortunately changing either
of these aspects would cause backcompat problems for existing deployments
now :-( So we just have to accept that the global config file is always
in present, but none the less libvirt should try to specify things as
fully as possible.

Regards,
Daniel
-- 
|: https://berrange.com      -o-    https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org         -o-            https://fstop138.berrange.com :|
|: https://entangle-photo.org    -o-    https://www.instagram.com/dberrange :|



reply via email to

[Prev in Thread] Current Thread [Next in Thread]