[Qemu-ppc] [PATCH for-2.13 03/10] target/ppc: Remove unnecessary initialization of LPCR_UPRT

[David Gibson]

In cpu_ppc_set_papr() the UPRT and GTSE bits of the LPCR are initialized
based on on ppc64_radix_guest().  Which seems reasonable, except that
ppc64_radix_guest() is based on spapr->patb_entry which is only set up
in spapr_machine_reset, called much later than cpu_ppc_set_papr().

So the initialization here is pointless.  The base cpu initialization
already sets a value that's good enough until the guest uses an hcall to
configure it's preferred MMU mode.

Signed-off-by: David Gibson <address@hidden>
---
 target/ppc/translate_init.c | 16 ----------------
 1 file changed, 16 deletions(-)

diff --git a/target/ppc/translate_init.c b/target/ppc/translate_init.c
index bb79d23b50..14f346f441 100644
--- a/target/ppc/translate_init.c
+++ b/target/ppc/translate_init.c
@@ -8897,22 +8897,6 @@ void cpu_ppc_set_papr(PowerPCCPU *cpu, 
PPCVirtualHypervisor *vhyp)
     lpcr->default_value &= ~LPCR_RMLS;
     lpcr->default_value |= 1ull << LPCR_RMLS_SHIFT;
 
-    if (env->mmu_model == POWERPC_MMU_3_00) {
-        /* By default we choose legacy mode and switch to new hash or radix
-         * when a register process table hcall is made. So disable process
-         * tables and guest translation shootdown by default
-         *
-         * Hot-plugged CPUs inherit from the guest radix setting under
-         * KVM but not under TCG. Update the default LPCR to keep new
-         * CPUs in sync when radix is enabled.
-         */
-        if (ppc64_radix_guest(cpu)) {
-            lpcr->default_value |= LPCR_UPRT | LPCR_GTSE;
-        } else {
-            lpcr->default_value &= ~(LPCR_UPRT | LPCR_GTSE);
-        }
-    }
-
     /* Only enable Power-saving mode Exit Cause exceptions on the boot
      * CPU. The RTAS command start-cpu will enable them on secondaries.
      */
-- 
2.14.3