[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xlog-discussion] Hamlib in 1.8: No QSO-pane data
From: |
Joop Stakenborg |
Subject: |
Re: [Xlog-discussion] Hamlib in 1.8: No QSO-pane data |
Date: |
Sun, 31 Aug 2008 10:07:15 +0200 |
Op zaterdag 30-08-2008 om 19:35 uur [tijdzone -0400], schreef John B.
Egger:
> I just updated Xlog 1.7 to 1.8. Hamlib provides a frequency readout in
> my statusbar, as I requested, but Ctrl-K adds no information from the
> transceiver to the QSO pane (only the date and time).
>
> I'm using the same parameters (selection of radio and device) as in 1.7
> (which I still have installed on a laptop, so comparisons are easy). The
> ChangeLog didn't seem to show anything related to this.
>
> Anyone else experiencing this, or have I misconfigured 1.8 somehow? I
> compiled it from the .tar.gz file, since I use a Debian (Kubuntu-based)
> system. Everything looks fine, except that Ctrl-K doesn't pull in the data.
>
Rob, KL7NA reported the same problem to me in a private mail. I will
have a look at it later this week and when fixed, will make a 1.8.1
release.
Regards,
Joop PG4I