[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Build problems for m4 target with make distcheck

From: Stephen Torri
Subject: Build problems for m4 target with make distcheck
Date: 29 Sep 2002 23:05:42 -0400


When I can configure and compile a project that I am working on the
automake and autoconf files. When I run "make -j4" it works fine. But
when I try to do "make distcheck" I get back:

config.status: creating po/POTFILES
config.status: creating po/Makefile
config.status: executing default commands
make[1]: Entering directory
make[1]: *** No rule to make target `m4//_xine.m4', needed by
`../aclocal.m4'.  Stop.
make[1]: Leaving directory

The Makefile line in question I believe is:

$(ACLOCAL_M4): m4//_xine.m4 m4//aa.m4 m4//codeset.m4
m4//gettext.m4 m4//glibc21.m4 m4//iconv.m4 m4//isc-posix.m4
m4//lcmessage.m4 m4//ORBit.m4 m4//progtest.m4 m4//readline.m4
        cd $(srcdir) && $(ACLOCAL) $(ACLOCAL_AMFLAGS)

The from the m4 directory says:

## Process this file with automake to produce

        ORBit.m4 \
        aa.m4 \
        codeset.m4 \
        gettext.m4 \
        glibc21.m4 \
        iconv.m4 \
        isc-posix.m4 \
        lcmessage.m4 \
        progtest.m4 \
        readline.m4 \

I cannot see what is up here. I apologize for posting to two lists but I was 
which one was most relevant.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]