[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [avr-gcc-list] Some working example code for ATMega163

From: Larry Barello
Subject: Re: [avr-gcc-list] Some working example code for ATMega163
Date: Tue, 22 May 2001 06:55:00 -0700

I recently rebuilt my robot code (www.barello.net/Robots/Dilbert2) as 163
vs 8535 and aside from two hitches worked perfectely out of the box:

1. The mega163 I got had the internal R/C oscillator set - until I figured
this out and reset the fuse bits the code ran real slow...  By the way,
there are a *lot* of fuse bits for that chip.

2. I couldn't get the code to run reliably until I bumped the Vcc to 6.0
volts (STK500 - great development board) - then I finally figured out that
9.86mhz crystal was actually 16mhz - oops.  Once I got a proper 9.6mhz
crystal (yeah, I know, I am overclocking the chip) things worked properly
down to 3.0 volts or so.

As far as I can tell, aside from the 4 byte entries in the interrupt vector
table and the usual shuffling of vectors, everything else is backward
compatible with the 8535, bit for bit.


----- Original Message -----
From: "Robert Rozman" <address@hidden>
To: <address@hidden>
Sent: Tuesday, May 22, 2001 1:55 AM
Subject: [avr-gcc-list] Some working example code for ATMega163

> Hello,
> I'm migrating from 8535 to ATMega163 and code doesn't work. So any
> working 'example like' source code for ATMega163 would be of great help,
> just to verify that my programmer is doing the job OK also on Mega163 (I
> have stk200 dongle and Ponyprog 2000).
> Is there any other software solution for programming Mega163  with
> stk200 dongle ?
> Thanks in advance,
> Robert Rozman
> _______________________________________________
> avr-gcc-list mailing list
> address@hidden
> http://avr.jpk.co.nz/mailman/listinfo/avr-gcc-list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]