[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [avr-gcc-list] ATmega128 page programming times

From: Waldner, Ed
Subject: RE: [avr-gcc-list] ATmega128 page programming times
Date: Mon, 23 Dec 2002 13:00:26 -0500

I'm running the part at 5V with a 7.73728 MHz clock. Although the data sheet does not specify which crystal setting it uses for determining the write times, but since it lists a max time setting, I assume this is the worst case (ie: 3.3V). I could be wrong though.
-----Original Message-----
From: Jesper Hansen [mailto:address@hidden
Sent: Monday, December 23, 2002 12:15 PM
To: Waldner, Ed; address@hidden
Subject: Re: [avr-gcc-list] ATmega128 page programming times

Normally, the programming times is highly dependent on the supply voltage.
The datasheet normally specifies at 5V, so if you're using a lower voltage, that
would explain it.
Merry Christmas.
----- Original Message -----
Sent: Monday, December 23, 2002 5:09 PM
Subject: [avr-gcc-list] ATmega128 page programming times

Hello everyone,

Happy holidays!

Just in case anyone is still working, I have a question with respect to flash page programming times on the ATmega128.

My routine to perform a page erase takes 4.24 msec and a page write takes 4.2 msec. The data sheet specifies that the entire page programming operation (erase, write, lock bit programming) takes at most 4.5 msec.

Does anyone have experience with these times?


reply via email to

[Prev in Thread] Current Thread [Next in Thread]