[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [avr-gcc-list] Fw: Make Your Own JTAGICE box

From: Lee Davies
Subject: RE: [avr-gcc-list] Fw: Make Your Own JTAGICE box
Date: Thu, 24 Apr 2003 14:41:29 +0100

I tried using the following command to convert the binary file into hex

srec_cat -o upgrade.hex -Intel upgrade.ebn -binary

However when I programmed my self built JTAGICE, AVRstudio failed to find it

I could post the converted hex file to determine whether the hardware is at
fault or the bin->hex conversion. However I'm not sure whether that's legal



-----Original Message-----
From: Larry Barello [mailto:address@hidden
Sent: 24 April 2003 14:03
To: Lee Davies; AVR GCC List
Subject: Re: [avr-gcc-list] Fw: Make Your Own JTAGICE box

Hmm, it sounds like making the bootloader and using that technique to
load the JTAG ice will be required.  Follow the direction on the
original email.  It provides the binary to load as the bootloader.

----- Original Message -----
From: "Lee Davies" <address@hidden>

> Hello,
> I've tried programming the device using AVRPROG, however the device
> to verify.
> I've also tried programming the device using an STK500, however AVR
> complains the file is not a valid HEX file.
> Has anybody else tried programming the device using the SKT500 ?
> If so, is any BIN->HEX conversion required ?
> What is the preferred conversion package ?
> Any help would be appreciated,

reply via email to

[Prev in Thread] Current Thread [Next in Thread]