[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] Programming Circuit for AVRDUDE
From: |
Jamie Morken |
Subject: |
Re: [avr-gcc-list] Programming Circuit for AVRDUDE |
Date: |
Fri, 13 Jun 2003 19:02:28 -0700 |
Hi,
- sorry last email sent itself while I was writing it
> My question: is there a simple (i.e. something that could be built on a
> breadboard) programming circuit that can be used to program AVR's. I have
> read through the AVRDUDE manual and it seems promising, but does not
contain
> any information on the circuits themselves. Are there major limitations
to
> programming AVR's in this manner (as opposed to using an STK500)? What
will
> I not be able to do (there is some meantion of certain fuses not being
> accessible in parallel or serial programming modes)?
If you want to buy a programmer instead:
http://www.olimex.com/dev/avr-pg2b.html
($10US)
There are also other people selling the programmers, have a look at the
avrfreaks website.
>
> Can I use AVRDUDE with an appropriate circuit to program in a bootloader?
The above programmer will work for that, you will have to look into the avr
fuse bits to setup the bootloader though.
cheers,
Jamie Morken
>
> Thanks,
> Donovan
>
>
>
> _______________________________________________
> avr-gcc-list mailing list
> address@hidden
> http://www.avr1.org/mailman/listinfo/avr-gcc-list
>
Re: [avr-gcc-list] Unused registers saves/restores ?, E. Weddington, 2003/06/09