[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[avr-gcc-list] Re: uisp 20030618 released

From: diz rael
Subject: [avr-gcc-list] Re: uisp 20030618 released
Date: Wed, 18 Jun 2003 11:05:38 -0700 (PDT)

Usually, I access the device through the parallel
port, and use the following command:

uisp -dprog=dapa --erase.. or whatever

But with this version, it gives the following error:

An error has occurred during the AVR initialization.
 * Target status:
   Vendor Code = 0xff, Part Family = 0xff, Part Number
= 0xff

Probably the wiring is incorrect or target might be

If I change it to
uisp -dprog=dapa --erase -dpart=atmega128

it doesn't give errors, but the fuses (in terminal
mode) are all wrong.. everything is displayed as 0xff.
In fact, even if the device is turned OFF, it doesn't
give any errors, but the entire flash reads 0x00, and
the fuses too.

Is this a commonly seen problem?


Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!

reply via email to

[Prev in Thread] Current Thread [Next in Thread]