Re: [avr-gcc-list] atmega32 problems

[Jamie Morken]

Hi,

"When the JTAG interface is enabled, this pin can not be
used as an I/O pin."  (referring to port C bits 5 to 2)

got it :)

thanks!
Jamie Morken


----- Original Message ----- 
From: "Artur Lipowski" <address@hidden>
To: <address@hidden>
Sent: Sunday, August 24, 2003 10:34 PM
Subject: Re: [avr-gcc-list] atmega32 problems


> Jamie Morken wrote:
> > I am getting strange outputs from my atmega32 (5Volt 40pin dip version).
> > The below code should set all portc pins to 5Volts but one of the portc
pins
> > is floating around 1.2volts and another portc pin stays at about
4.5volts.
> ...
> Hint: try serarch the Mega32 datasheet for the spell "JTAGEN" 8-)
>
> Regards,
> -- 
> Artur Lipowski
>
>
> _______________________________________________
> avr-gcc-list mailing list
> address@hidden
> http://www.avr1.org/mailman/listinfo/avr-gcc-list