[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [avr-gcc-list] AVR ISP Error

From: Daniel Mayo
Subject: Re: [avr-gcc-list] AVR ISP Error
Date: Thu, 25 Aug 2005 08:23:01 -0500
User-agent: Mozilla Thunderbird 1.0.2 (Windows/20050317)

Where is the 'program' button on the AVRISP?

Andi Suhandi wrote:

To Upgrade the firmware you have to:
1. Turn off the STK
2. Press "Program" Button on STK
3. Turn on the power STK ("Program" button still pressed)
4. Run the "Upgrade.exe" program in directory C:\Program Files\Atmel\AVR
   Press "Start Upgrade" button
5.Then you can release "Program Button"
6. Wait till upgrade done

I hope it will help


----- Original Message -----
From: "Daniel Mayo" <address@hidden>
To: "AVR GCC List" <address@hidden>; "AVR Chat"
Sent: Thursday, August 25, 2005 3:17 AM
Subject: [avr-gcc-list] AVR ISP Error

I just got two new AVR ISPs from Digikey and am getting this error when
I try to connect to them via AVR Studio 4.11 Build 401 which seems to be
the latest at atmel.com

"An AVRISP with firmware version 2.01 has been detected.  The firmware
corresponding to this installation of AVR Studio is 2.00.  Press OK to
launch the upgrade program to perform a downgrade, or Cancel without
downgrading.  NOTE! Correct operation is not guaranteed if a downgrade
is not performed."

If I press Cancel it seems as though everything works.
If I press Ok, AVR Studio launches the Atmel STK500/AVRISP Upgrade
program but after doing something to the AVRISP so that the LED goes out
it then reports that no programmer could be found, and thus no update is
performed, and then AVR Studio can't detect the AVRISP until I close AVR
Studio AND cycle power to the AVRISP.

How do I get rid of either the first warning or the error updating so
that I can resolve this?

I have looked online at atmel.com and avrfreaks.com, with no luck.

AVR-GCC-list mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]