[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[avrdude-dev] jtagmkii not working for me
From: |
Emil |
Subject: |
[avrdude-dev] jtagmkii not working for me |
Date: |
Thu, 06 Oct 2005 21:42:51 -0000 |
User-agent: |
Mutt/1.4i |
I have a JTAGICE MKII serial interface which works fine with
avarice but fails with avrdude. Both programs use the serial
interface at 19200 bauds.
$ avrdude -P /dev/ttyS0 -c jtagmkii -p m128 -vvv
avrdude: Version 5.0
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
System wide configuration file is "/etc/avrdude.conf"
User configuration file is "/home/emil/.avrduderc"
User configuration file does not exist or is not a regular
file, skipping
Using Port : /dev/ttyS0
Using Programmer : jtagmkii
avrdude: jtagmkII_open()
avrdude: jtagmkII_getsync()
avrdude: jtagmkII_getsync(): Sending sign-on command:
avrdude: jtagmkII_send(): sending 1 bytes
avrdude: jtagmkII_recv():
avrdude: ser_recv(): programmer is not responding
avrdude: jtagmkII_recv(): Timeout receiving packet
avrdude: jtagmkII_getsync(): sign-on command: status -1
avrdude: jtagmkII_getsync(): Sending sign-on command:
avrdude: jtagmkII_send(): sending 1 bytes
avrdude: jtagmkII_recv():
$ avarice --jtag /dev/ttyS0
AVaRICE version 2.3, Oct 6 2005 17:31:43
Defaulting JTAG bitrate to 1 MHz. Make sure that the target
frequency is at least 4 MHz or you will likely encounter failures
controlling the target.
JTAG config starting.
Hardware Version: 0xc0
Software Version: 0x78
Reported JTAG device ID: 0x9702
Configured for device ID: 0x9702 atmega128
JTAG config complete.
--
Regards,
Emil
--
Don't walk on the grass, smoke it.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [avrdude-dev] jtagmkii not working for me,
Emil <=