Kyle N Winfree<address@hidden> writes:
Thanks for the quick response. Attached are the contents from
make
make.log when I simply ran it again this morning. I'm not too
familiar with using make, are there reasons why I shouldn't simply run
make again after the first attempt failed? Should I have rerun
configure first?
It's perfectly fine to run "make" as many times as you want.
Developers do that over and over again all day long.
You don't need to run configure again.
Thank you for sending more of the "make" output, but,
unfortunately, the important part was again left out. Would you
mind sending the full output? Even if it's several pages long,
it will give the information that we need to diagnose the
problem.
Thanks,
Ben.