[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Bug-gnubg] bug: reedit cube position

From: Jon Kinsey
Subject: Re: [Bug-gnubg] bug: reedit cube position
Date: Thu, 09 Oct 2003 11:53:10 +0100

At 11:03 09/10/2003, Achim Mueller wrote:
I just tried to edit a position again, where I set cube at the wrong
value. There seems to be no possibility in the gui to reset a cube
from owner back to middle or change the value again.

Also a commandline "set cube value/owner" shows no effect.
Hi Achim,

Can you give some more detail, I just did the following with the 3d/panel build (2d board):

1 start 5pt match
2 edit position, click cube, set to 4 at top, end edit
3 edit position again, click cube, set to 1 (64) in middle, end edit

All ok.  The set cube command worked too.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]