PassingBootParameter?

[ThomasRatliffDDS]

Can't seem to get the syntax correct on passing boot parameter to my
kernel with a grub boot disk

With a boot disk (?lilo?)
                ide3=0xfff0,0xffff,9
works.

And from within a lilo configuration
                append="ide3=0xfff0,0xffff,9"
works.

My linux redhat7.2 installation is on a UDMA100 disk attaced to a UDMA133
controller and the identification of this ide bus required the boot
parameter above with lilo.

I can see an error message regarding .....pci.... flash by as the kernel
attempts to boot and before it hangs.

thanks