[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Grub not working with no VGA controller?
From: |
Liberty Young |
Subject: |
Grub not working with no VGA controller? |
Date: |
18 Jul 2002 15:29:41 -0700 |
I'm working on with grub installed on a DiskOnChip on a Single Board
Computer (embedded pc). Grub will not boot past stage2 with no VGA
controller on the SBC.
I have grub working just fine on the diskonchip when a VGA daughter
board is installed on the SBC. I have in my menu.lst the options for
serial output:
serial --unit=1 --speed=9600 (i have also tried adding --port=ttyS1 and
--dumb)
terminal serial
As expected, i have a serial interface, though again, when i have a VGA
daughter board mounted on the SBC.
With no VGA daughter board, Grub loads as normal, but after stage2 (with
the string of dots following), the system hangs. I get no output, no
menu, and worse, no boot of my system.
One thing to note: Our BIOS redirects stdout to the console.
Any ideas on how to resolve this?
- Grub not working with no VGA controller?,
Liberty Young <=