[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: guile-1.8.1 tarball missing config.rpath
From: |
Neil Jerram |
Subject: |
Re: guile-1.8.1 tarball missing config.rpath |
Date: |
Fri, 17 Nov 2006 14:19:43 +0000 |
User-agent: |
Gnus/5.1007 (Gnus v5.10.7) Emacs/21.4 (gnu/linux) |
Ralf Wildenhues <address@hidden> writes:
> Hello bug-guile readers,
>
> The tarball at ftp://ftp.gnu.org/gnu/guile/guile-1.8.1.tar.gz
> has a configure script that uses the script config.rpath. But
> this script is not shipped with the tarball. This can cause
> "interesting" and weird bugs, if I remember correctly, on some
> systems at least. It shows up as a warning during configure.
>
> A likely cause for the omission is that gettextize is needed to
> install this for you. Also I think when you update the package
> to use Automake 1.10, a gettext-induced check for the presence
> of the config.rpath file will be enabled (so this doesn't happen
> again).
Forgive my slowness (both in responding and in understanding), but I'm
not sure I'm clear about what possible fixes you're suggesting. The
two possibilities that I deduce from the above are:
1. Add config.rpath to Guile CVS and EXTRA_DIST in the top level
Makefile, so that it's always, unconditionally present.
2. Make sure that whoever prepares the release has Automake 1.10; then
automake --add-missing will install config.rpath as a side effect
of the AM_GNU_GETTEXT declaration in configure.in.
Is that right? Are there any other possibilities?
Regards,
Neil