Hello Guix hackers,
Running 'guix pull' on a fresh basic install of Guix System 1.3.0 for i686 gets stuck at around 80%.
I've tested this several times and it happens most of the time. In the other rare few cases other errors showed up. Not a single 'pull' succeeded either way.
I let the pull run for days sometimes but it never finishes.
I run Guix x86_64 on my other systems without issues in the same environment.
I tested this on a Pentium 4 32bits laptop with 786MB RAM at first, and then switched to a VM with 8 GBs RAM, 2+ cores, 60GBs SSD to avoid any resources issues.
Terminal log of one of the runs and config.scm attached.
Let me know if there's anything I can help with.
Regards,
Ahmad
config.scm