bug-gzip
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

bug#22070: Recreating release 1.6 from git


From: Doug Evans
Subject: bug#22070: Recreating release 1.6 from git
Date: Tue, 1 Dec 2015 15:00:18 -0800

Ok, last question and then you can close this.

I'm trying to verify the correct version of gnulib is being used,
but I can't see anything in the bootstrap script that
guarantees this. E.g., I expected to find a gnulib commit id
or tag or some such that specified the version of gnulib that
was used when the original 1.6 release was made.
Do you know how this is done?

Thanks again!


On Tue, Dec 1, 2015 at 2:14 PM, Doug Evans <address@hidden> wrote:
> On Tue, Dec 1, 2015 at 1:33 PM, Jim Meyering <address@hidden> wrote:
>> On Tue, Dec 1, 2015 at 10:09 AM, Doug Evans <address@hidden> wrote:
>>> Hi.
>>>
>>> Is there a recipe for recreating (as close as possible, but not
>>> necessarily identical to) the 1.6 release from git?
>>>
>>> There is a v1.6 tag so I can begin with that.
>>> It's the next step I'm not clear on.
>>> I can run the bootstrap script and get something that's buildable,
>>> but I'm left with, IIUC, all of gnulib instead of just the pieces that
>>> went into the 1.6 release.
>>>
>>> There's also the issue of using the same autoconf/automake/etc. but I
>>> can manage that as needed.
>>
>> Hi Doug,
>>
>> You should be able to come very close by looking at
>> the release announcement (for selected autotools
>> releases) and then following the steps in README-release.
>> Bottom line, "make dist" does the job.
>
> Indeed.  :-)
>
> IWBN if these instructions were in README-hacking or some such.
> Or at least a pointer to where to find them.
> There is README-release but it's generated at "make dist" time
> (presumably for good reasons, but there's good stuff in there
> that would be nice to be able to easily find after a git clone
> and before anything else).





reply via email to

[Prev in Thread] Current Thread [Next in Thread]