[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: print does not work under 1.4.8?

From: Andrew Clausen
Subject: Re: print does not work under 1.4.8?
Date: Thu, 01 Feb 2001 09:50:18 -0200

address@hidden wrote:
> I have an ext2 file system on a 1.2G drive which I would like to shrink down 
> to 900M so that I can add a boot partition to the drive (and thereby restore 
> the system).
> When using parted 1.4.8 the print command gives me:
> Minor   Start      End      Filesystem  Flags
> 1     0.000 12419.056   Ext2
> When I do a resize the system gets busy for a bit and then simply comes back 
> to a command prompt leading me to believe that the FS really has been 
> resized.  However the print command still shows the same size.
> What gives?
> As an experiment I statically linked ext2resize and used it to resize the 
> partition down to 900M.  The same thing happens.  The command is obviously 
> doing something and does not report anything wrong.  However parted print 
> still shows a size of 12419...

What did you type, to start Parted?  Can you show me the ENTIRE output
of the print command?

Andrew Clausen

reply via email to

[Prev in Thread] Current Thread [Next in Thread]