[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Denemo-devel] 2.0.0 and 1.2.4 bad font

From: Lars Björnfot
Subject: Re: [Denemo-devel] 2.0.0 and 1.2.4 bad font
Date: Sat, 17 Oct 2015 15:19:58 +0200

No panic, I had not done a reboot. (Mea culpa)

The 2.0.0 zip worked. It creates denemo.ttf in

The 2.0.0 installer now also works when i re-installed it. 
Fonts are OK even though there is no C:\Windows\Fonts\denemo.ttf.
The installer gave error:   Invalid file handle 32
Maybe that is about font installation failing. Then maybe this will be a 
problem for others installing on a clean system. 

Anyhow, the zip offers a straight-forward workaround!


-----Ursprungligt meddelande-----
Från: Richard Shann [mailto:address@hidden 
Skickat: den 17 oktober 2015 10:15
Till: Lars Björnfot <address@hidden>
Kopia: address@hidden
Ämne: Re: [Denemo-devel] 2.0.0 and 1.2.4 bad font

On Fri, 2015-10-16 at 21:30 +0200, Lars Björnfot wrote:
> I have used 1.2.2 which was ok but crashed once in a while. This was 
> on Windows 7, and later on Windows 10.
> I tried 2.0.0. It gives all text in some bad font, menus and buttons 
> become unusable. (see screenshot)

did you reboot? This failure to find fonts happens almost always until reboot.

> I tried 1.2.4 but it failed same way.

1.2.4 is defective, it fails to install the fonts - unless you have previously 
installed on that machine it will fail in that way..

> Any ideas? 
> I’m just trying it for fun… no panic. J

Well, it will be a panic for me if 2.0.0 is defective in this way. I'm hoping 
you didn't re-boot after installing, that would explain it.
You can check that C:\Windows\Fonts\denemo.ttf exists, provided that exists, 
rebooting should be enough for windows to find it.

p.s. the zip file, besides being portable does not have these problems and 
should always work, as Jeremiah mentioned.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]