[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Install problem

From: Paul J. Zawada
Subject: Re: [Discuss-gnuradio] Install problem
Date: Wed, 25 Jun 2003 21:05:55 -0500

I'm more of a hardware guy, so take my advice FWIW...

I think this may be a Qt compatibility problem. Even though you may have the right version of the Qt libraries, sometimes you can't build against them if they were compiled with a version of gcc than what you are building. This is a problem I ran into when I built GNU Radio on Red Hat 8.0. I don't recall the exact compile errors, but once I downloaded the Qt source, compiled it, and reinstalled Qt, I was able to successfully build the example programs...

Good Luck!


At 4:11 PM -0600 6/25/03, Joseph DiVerdi wrote:
I am knee-deep in a new gnuradio install on a new system, have hit a wall, and am seeking counsel.

The system configuration follows:

233MHz AMD K6
6.4GB disk
0.5GB swap disk
RH v8.0 (gcc v3.2)
FFTW v3.0
gnuradio v0.8

configure, make, make check, and make install proceed without errors.

I am now working in the examples directory where (1) none of the programs are built during the standard installation process and (2) errors are thrown in response to a make manually made in the examples directory. A representative error stream follows:

[ Ugly Details omitted ]

Paul J. Zawada, PE       | Principal Network Research Engineer
address@hidden          | National Center for Supercomputing Applications
+1 217 649 2233          | University of Illinois at Urbana-Champaign

reply via email to

[Prev in Thread] Current Thread [Next in Thread]