[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Viewing square wave in usrp_oscope
From: |
sudhindra aithal kota |
Subject: |
Re: [Discuss-gnuradio] Viewing square wave in usrp_oscope |
Date: |
Fri, 18 Nov 2005 03:21:09 +0000 (GMT) |
Hi,
Sorry for the previous mail. Totally out of context.
I gave a square wave input direct from a signal
generator and the behaviour of usrp_oscope was the
same as I had explained before. I increased the
frequency to way above 100KHz. Is there any other
option to be given?
Regards
Sudhindra
> Hi,
> Is it possible to view a square wave using
> usrp_oscope.py? I have a circuit which produces a
> square wave that I want to view.
Yes.
> I know usrp_oscope is not a general purpose
> oscilloscope. We eventually want to manipulate the
> signal coming from the circuit for our purposes. So
we
> wanted to know if it is represented properly.
> The square wave had spikes in it. It appeared more
> like a capacitor charging and discharging. And at
high
> frequencies, it resembles a sine wave. The signal
> coming from the circuit has a frequency of 41 KHz.
If you are using the Basic Rx daughterboard as your
input, the RF
transformer on it acts as a high pass filter.
Try using an input signal > 100kHz. A megahetz would
be even better.
> Has anyone tried working with a square wave before
> and faced this problem? Please let me know how to
> correct this. Thanks
The Basic USRP has a 50 Ohm input impedance.
Will your circuit drive 50 ohms?
Eric
__________________________________________________________
Enjoy this Diwali with Y! India Click here
http://in.promos.yahoo.com/fabmall/index.html