[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Basic RX/TX
From: |
Thomas Schmid |
Subject: |
[Discuss-gnuradio] Basic RX/TX |
Date: |
Sat, 27 May 2006 12:16:56 -0700 |
Hi,
I have a question about the basic RX/TX boards. What should I see if I
hook the basic TX board to an oscilloscope if I send out a QPSK
signal? Here is what I do:
- I generate a QPSK signal in GnuRadio
- I send the signal to a complex file source and the signal looks right
- I send the signal to the complex USRP source and have a BasicTX on
it. The outputs TXA and TXB are hooked up to a oscilloscope on channel
1 and 2 respectively.
Now, what should I see on the oscilloscope? Is it the baseband signal?
How does the I and Q phases get mixed together? Does that depend on
the mux values? Unfortunately I couldn't find a good block diagram of
the TX path on the wiki, i.e., the link to [A system block diagram of
the USRP receiver and transmitter path] on the wiki page
"http://www.comsec.com/wiki?UniversalSoftwareRadioPeripheral" is dead.
Cheers,
Thomas
- [Discuss-gnuradio] Basic RX/TX,
Thomas Schmid <=